Release v1.9.42, 2026-11-15
What's new: X-ray stickers
A replacement for the kit's battery box, made for this build. It keeps the original cell pocket for the two 18650 cells and adds a skirt round the board stack: the Uno Q and the expansion board lie on a flat shelf (13.6 mm from the Uno Q's underside to the expansion board's top face, as measured) and the kit's four M3 x 16 screws go through both boards into the box.
The lid sits close to the boards with its back crowned, so a duck that falls on its back rolls onto a side. Two M2 x 6 countersunk screws hold it, flush. There are openings over the expansion board's connectors and the battery plug, for the Uno Q's USB C, the charging socket and the power switch.
Print the box and the lid upright, as they sit on the duck, their bottom ends on the bed; the files come turned that way. The lid goes on at build step 113.
Its power switch is in the top, by the battery plug, and its charging socket is in the left side, so this pack has its own openings and a deeper lid.
The first board: its power switch in the left side and its charging socket underneath.
Every other printed part, the assembly guide and the bill of materials come from Luwu Dynamics' XGO-Duck hardware repository. Download them there, so you have their latest files.
XGO-Duck is by Luwu Dynamics, built on Microduck by Pollen Robotics. The XGO-Duck part models, assembly guide pictures and video stills in this viewer are theirs, used with Luwu Dynamics' permission. XGO-Duck Parts (this viewer) and the battery and board pack are by MrRobotoW, maker of the 3D Pal World Viewer. Send me a message.
Viewer and pack © 2026 Digimals. All rights reserved. Digimals® is a registered trademark.